Sliding cantilever gates are suspended over the gate opening by a set of 4 high quality sealed bearing cantilever rollers
mounted to two 4" round posts. A cantilever gate is easier to install than a
ground track slider
and is good for snow country because there is no track across the drive. The back-frame on these gates is 30% to 40% of the opening width so they require more side room than a ground track installation.
Not sure if you need a swing
or sliding gate?
Athena Cantilever Gate - Sliding Gate System
Standard Cantilever System Requires:
Hot Dipped Galvanized Steel
Slide Gate (one style)
Non-reach-through wire mesh
Four UHMW sealed bearing
Slide gate operator from
Two 4" round cantilever posts (HDG)
Typical Cantilever Gate (Diagrams)
Please call us at 1-877-313-8901 for help with your sliding gate project.